BMW X3 Service & Repair Manual: Notes on repairing threads (B)

IMPORTANT: Install Helicoil thread inserts so that they are flush with the original thread.

NOTE: Damaged threads on the engine support may be repaired with Helicoil thread inserts. Follow the procedure described in the example.

Driveline+Axles

Procedure:

1. Create a clean core hole; if necessary, drill out screw remnants

Driveline+Axles

2. Create locating thread for Helicoil thread insert

Driveline+Axles

3. Pick out Helicoil thread insert in accordance with the TABLE and screw into the locating thread until flush with the original thread

Driveline+Axles

4. Break drive pin and remove

Driveline+Axles

OVERVIEW OF FRONT AXLE DIFFERENTIAL/OUTPUT SHAFTS

Driveline+Axles

Driveline+Axles

    Notes on repairing threads (A)
    IMPORTANT: Install Helicoil thread inserts so that they are flush with the original thread! NOTE: Damaged threads may be repaired with Helicoil t ...

    Raising vehicle with trolley jack
    Observe the following trolley-jack-related instructions: 1. Only trolley jacks sold or approved by BMW, with a rubber plate on their mounting, may ...

    Other materials:

    BMW X3 Service & Repair Manual > Struts with rubber mounts: Removing and installing/replacing guide joint in swivel bearing
    Necessary preliminary work: Remove TENSION STRUT FROM GUIDE JOINT. IMPORTANT: Check the rubber gaiter and circlip for damage! When removing and installing the trailing link, check the seat of the circlip seal between the trailing link and the wheel control joint and replace the wheel ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0772