BMW X3 Service & Repair Manual: Replacing rubber mount for trailing arm in wheel carrier

BMW X3 Service & Repair Manual / Driveline+Axles / Control arms and struts / Replacing rubber mount for trailing arm in wheel carrier

Special tools required:

  • 0 496 553
  • 0 496 554
  • 2 293 777
  • 2 293 768
  • 2 293 772

Necessary preliminary tasks:

  • Remove REAR WHEEL .
  • Remove TRAILING ARM.
  • Remove CAMBER ARM FROM WHEEL CARRIER.

Withdrawing rubber mount: Pull out rubber mount with special tools 0 496 553, 0 496 554, 2 293 777 and 2 293 768 against direction of travel (F).

Driveline+Axles

Installing rubber mount: Pull in rubber mount (1) against direction of travel (F) with special tools 0 496 553, 0 496 554, 2 293 777 and 2 293 772 up to limit position.

Driveline+Axles

    Replacing left or right trailing arm
    IMPORTANT: The trailing arm must be installed with the opening (U-section) facing downward! If the trailing arm is bent, the control a ...

    Replacing rubber mount for wishbone in wheel carrier
    Special tools required: 0 496 553 0 496 554 2 293 768 2 293 777 2 293 770 Necessary preliminary tasks: Release WISHBONE ON WHEEL CA ...

    Other materials:

    BMW X3 Service & Repair Manual > Automatic transmission: Bush
    Bush Minimum set: Mechanical tools AM NOTE: For transmission without positioning switch Transmission: A4S 310R Deletion, only available via tool set Bush Minimum set: Mechanical tools AM NOTE: (Threaded bush) Bush Mechanical tool Replaced by: 83300491781 NOTE: (Impact bush) For fi ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.051