Bush Mechanical tool
Replaced by: 83300492341
NOTE: (Impact bush) For radial seal on output flange - Replaced by 33 3 450. (0 492 341)
Bush AM
Replaced by: 83300493416
NOTE: (Clamping bush) Discontinuation and replaced by 33 4 400. (0 493 416)
Bush AM
NOTE: Series: E31, E46
Storage Location
C14
NOTE: For accommodating the trailing arm when pressing out
Storage Location
X5
NOTE: (Pressure bushing) For pressing the ball joint into the wishbone
NOTE: For accommodating the engine support arm or wheel carrier when pressing out the ball joint
Storage Location
X5
NOTE: (Pressure bushing) For pressing the ball joint out of the wishbone
NOTE: (Bush (for removal and installation)) Deletion, only available via tool set
Storage Location
C53
SI number
01 18 05 (214)
NOTE: For accommodating the leading link when pressing out
Storage Location
Z8
Bush Mechanical tool
NOTE: (Impact bush) For driving in the radial seal on the drive flange
Storage Location
X7
NOTE: For holding the wishbone when pressing out the rubber mount
Bush Mechanical tool
Replaced by: 83300492339
NOTE: (Impact bush) For fitting the radial sealing rings in the rear axle final drive on the drive flange - Replaced by 33 3 430. (0 492 339)
Replaced by: 83300492340
NOTE: (Impact bush) For radial sealing ring on the drive flange without axial sealing lip (final drive type G) and for fitting the radial sealing ring of the camshaft (M40) - Replaced by 33 3 440. (0 492 340)
BMW X3 Service & Repair Manual > Electronic switching or control units: Replacing pulse sensor on exhaust camshaft (N20)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Read out the fault memory of the DME control unit.
Switch off ignition.
Unlock connector (1) and remove.
Release screw (2).
Remove pulse sensor ( ...