Mandrel Mechanical tool
NOTE: (Drift) For driving in the retainer on the rear axle shaft
Storage Location
X8
Mandrel Mechanical tool
NOTE: (Guide mandrel) For fitting differential gear shaft into rear axle final drive
Storage Location
X4
Mandrel Mechanical tool
Replaced by: 83300492338
NOTE: (Drift) For radial seal on output flange - Replaced by 33 3 420. (0 492 338)
Mechanical Mandrel Minimum set: Mechanical tools 335080 tool
NOTE: For driving in shaft seal on drive shaft.
Storage Location
A16
SI number
01 21 06 (300)
Mandrel Mechanical tool
NOTE: (Drive-out mandrel) For the rear axle shaft/Replaced by 33 2 116. (0 492 175) and 33 4 200. (0 492 436)
Mandrel Mechanical tool
NOTE: (Drift) For driving in the retainer on the rear axle shaft (wheel bearing) and on the drive flange of the rear axle final drive (final drive types K and M)
Storage Location
A16
SI number
01 03 91 (333)
Mandrel Minimum set: Mechanical tools AM
NOTE: (Drift) For driving radial shaft seal of output shaft into rear axle final drive. Rear axle final drive: 215
Storage Location
B21
C21
SI number
01 01 07 (333)
Mandrel Mechanical tool
NOTE: (Drift) For driving in the radial seal rings in the rear axle final drive at the output flange with flange diameter 35 mm
Storage Location
X7
Mechanical Mandrel Minimum set: Mechanical tools 335130 tool
NOTE: For driving the radial shaft seal of the output shaft into the rear axle final drive.
Rear axle final drive: 188
Storage Location
C21
SI number
01 01 07 (333)
Mandrel Mechanical tool
Replaced by: 83300491891
NOTE: (Drift) Replaced by 31 2 040. (0 491 891)
Mandrel Minimum set: Mechanical tools Mechanical tool
NOTE: (Drift) For driving radial shaft seal onto drive flange. Replaced by 33 3 470/0 496 596
Storage Location
B26
SI number
01 09 09 (532)
Mandrel Mechanical tool
Replaced by: 83300492342
NOTE: (Drift) For driving the radial sealing ring into the output flange, flange diameter 43 mm - Replaced by 33 3 460. (0 492 342)
SI number
01 10 90 (288)
Mandrel Mechanical tool
Replaced by: 83300492338
NOTE: (Drift) For fitting the radial sealing ring, right-hand output end/Replaced by 33 3 420. (0 492 338)
Mandrel Mechanical tool
Replaced by: 83300492339
NOTE: (Drift) For driving the radial seal into the output flange with flange diameter 38 mm - Replaced by 33 3 430. (0 492 339)
Mandrel AM
NOTE: Discontinued, can only be ordered using complete tool
BMW X3 Service & Repair Manual > Front axle repair instructions: Raising vehicle with trolley jack
Observe the following trolley-jack-related instructions:
1. Only trolley jacks sold or approved by BMW, with a rubber plate on their mounting, may be used!
2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are
used!
3. Check the rubber plate ...