NOTE: The initialization finishes during driving, which can be interrupted at any time.
When driving resumes, the initialization is continued automatically.
1. Set the tire pressure of all wheels to specification.
2. Start engine, but do not start driving.
3. On Control Center, select "RPA" from the "SETTINGS" menu and confirm selection. The initialization menu will appear.
4. Select "SET" and confirm selection.
5. Drive vehicle. The message "FTM IS BEING INITIALIZED" will be displayed.
NOTE: It takes at least 10 minutes before the TPM system can detect and report a flat tire.
6. Select counterclockwise left arrow button and confirm to exit from menu.
BMW X3 Service & Repair Manual > Rear lid: Adjusting/replacing bump stops
Necessary preliminary tasks:
Remove luggage compartment wheel arch panel .
Following parts must not be damaged:
(1) Bump stop
(2) Lock nut (following illustration)
General view of rear side:
Adjust stop pads
Remove cap (1).
Adjust stop pad to correct height by turning screw (2) ...