BMW X3 Service & Repair Manual: Replacing output flange for front axle output (atc 450)

BMW X3 Service & Repair Manual / Transmission / Transfer box / Replacing output flange for front axle output (atc 450)

IMPORTANT: Do not move vehicle with drive power once propeller shaft has been removed.

Replace output flange only together with a new radial shaft seal.

After completion of work, check gearbox oil level.

Use only the approved TRANSMISSION OIL .

Failure to comply with this requirement will result in serious damage to the transfer box!

Operation is identical to REPLACING RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT.

REPLACING OUTPUT FLANGE FOR OUTPUT TO THE FRONT AXLE (ATC 45L)

IMPORTANT: Do not move vehicle with drive power once propeller shaft has been removed.

Replace output flange only together with a new radial shaft seal.

After completion of work, check GEARBOX OIL LEVEL.

Use only the approved TRANSMISSION OIL .

Failure to comply with this requirement will result in serious damage to the transfer box!

Operation is identical to REPLACING RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT.

    Removing and installing transfer box (atc 45l)
    Special tools required: 00 2 030 23 4 050 IMPORTANT: Before and after replacement, execute the "Repair" service function with the BMW di ...

    Replacing output flange on rear transfer box (atc 45l)
    IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary. Use only the approved TRANSMISSION OIL . NOTE: Re ...

    Other materials:

    BMW X3 Service & Repair Manual > Front axle: Laser
    Laser Minimum set: Mechanical tools AM LEVER Lever AM NOTE: Lever in connection with hydraulic cylinder (hydraulic actuator), (81 64 2 156 246), for removal and installation of wheel bearings, propeller shafts and drive flanges. SI number 08 06 09 (544) LOCATING FIXTURE Locati ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0088