BMW X3 Service & Repair Manual: Replacing grooved ball bearing in propeller shaft center bearing

BMW X3 Service & Repair Manual / Driveline+Axles / Center console assembly / Replacing grooved ball bearing in propeller shaft center bearing

Special tools required:

  • 23 1 160
  • 33 3 202
  • 33 3 203

Necessary preliminary tasks:

  • Replace PROPELLER SHAFT CENTER BEARING

Press grooved ball bearing using special tool 23 1 160 out of center mount (1).

NOTE: Illustration shows E46.

Driveline+Axles

Coat rubber-coated bearing seat of center mount (2) with Circolight.

Use special tools 33 3 202/33 3 203 to press grooved ball bearing (1) into center mount (2).

NOTE: Illustration shows E46.

Driveline+Axles

    Replacing complete propeller shaft center bearing
    Special tools required: 00 7 500 33 1 020 Necessary preliminary tasks: Remove PROPELLER SHAFT. NOTE: The propeller shaft is balance ...

    Front propeller shaft
    REMOVING AND INSTALLING FRONT PROPELLER SHAFT IMPORTANT: Do not move vehicle under its own drive power once propeller shaft has been removed. ...

    Other materials:

    BMW X3 Service & Repair Manual > Electronic components: Removing and installing/replacing emf actuator
    Necessary preliminary tasks: Release parking brake. Switch off ignition. IMPORTANT: Switch off ignition at least 30 s before disconnecting the plug connection! After installation, observe the following: switch on ignition and, using parking brake operating element, open parking ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0081