BMW X3 Service & Repair Manual: Removing and installing/replacing oil level sensor for engine oil (N47 D20 O1)

BMW X3 Service & Repair Manual / Electrical / Oil pressure/oil temperature/oil gauge / Removing and installing/replacing oil level sensor for engine oil (N47 D20 O1)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

  • Switch off ignition
  • Remove front UNDERBODY PROTECTION .
  • Drain ENGINE OIL .

Unlock connector (1) and remove.

Unscrew nuts.

Remove oil level sensor (2).

Installation note:

Clean sealing surface on oil sump.

Replace seal on oil level sensor.

An excessively low torque value will result in oil leaks.

An excessively high torque value will result in damage to the oil level sensor.

Electrical

Top up engine oil.

NOTE: Check stored fault messages.

Delete fault memory.

    Oil pressure/oil temperature/oil gauge
    ...

    Removing and installing/renewing oil level sensor for engine oil (N55)
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary tasks: Swit ...

    Other materials:

    BMW X3 Service & Repair Manual > Transfer box special tools: Device
    Device AM NOTE: For driving in the radial shaft seal in the transfer box on the output shaft at the front Consisting of: 1. Bush NOTE: (Slip bush) 2. Mandrel NOTE: (Drift) Device AM NOTE: For removing and installing the transfer box SI number 01 08 93 (679) Consisting of: ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0555