BMW X3 Service & Repair Manual: Removing and installing/replacing oil pressure sensor (N52T)

BMW X3 Service & Repair Manual / Electrical / Oil pressure/oil temperature/oil gauge / Removing and installing/replacing oil pressure sensor (N52T)

WARNING: Risk of burning! Only perform this repair work on an engine that has cooled down.

Necessary preliminary work:

Remove ACOUSTIC COVER

Installation location:

Oil filter housing, front left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Release connector (1) and remove.

Release oil pressure sensor (2).

Installation note:

Check oil level, top up engine oil if necessary.

Electrical

Removing and installing/replacing engine oil pressure/temperature sensor (N20, N26)

Special tools required: 34 5 160 Necessary preliminary tasks: Switch off ignition. Remove THROTTLE VALVE ASSEMBLY . WARNING: Risk of b ...

Removing and installing/replacing oil pressure sensor (N55)

Necessary preliminary work: Switch off ignition. Remove IGNITION COIL COVER. WARNING: Risk of burning! Only perform this repair work on an e ...

Other materials:

BMW X3 Owners Manual > Active Blind Spot Detection: Display
Lamp in the exterior mirror housing Information stage The dimmed lamp in the exterior mirror housing indicates when there are vehicles in the blind spot or approaching from behind. Warning If the turn signal is set while a vehicle is in the critical zone, the steering wheel vibrates bri ...