BMW X3 Service & Repair Manual: Replacing engine oil level sensor (N52T)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

  • Switch off ignition.
  • Remove REINFORCEMENT PLATE .
  • Drain ENGINE OIL .

Release connector (1) and remove.

Unscrew nuts.

Remove oil level sensor (2).

Installation note:

Clean sealing surface on oil sump.

Replace gasket on oil level sensor.

An excessively low torque value will result in oil leaks.

An excessively high torque value will result in damage to the oil level sensor.

Top up engine oil.

Electrical

NOTE: Check stored fault message.

Delete fault memory.

    Removing and installing/replacing oil pressure switch (N47 D20 O1)
    IMPORTANT: When working on the oil, coolant or fuel circuit, you must protect the alternator against dirt contamination. Cover alternator w ...

    Switches and relays
    REPLACING POWER DISTRIBUTION MODULE (N20, N52T, N55) Necessary preliminary tasks: Switch off ignition. Disconnect BATTERY NEGATIVE LEAD . Rem ...

    Other materials:

    BMW X3 Service & Repair Manual > Brake testing and bleeding: Removing and installing/replacing vent valve for brake caliper
    Necessary preliminary work: Raise vehicle. Removal: Press brake pedal down to floor and secure with pedal support. NOTE: The pedal support may only be released when the brake lines are reconnected. This prevents brake fluid from emerging from the expansion tank and air from enter ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0776