Adapter MP
NOTE: (Single adapter (8 pieces)) Deletion, only available via tool set
Storage Location
K 104
NOTE: For measuring secondary voltage during static ignition distribution
Storage Location
I 110
SI number
02 04 91 (321)
Consisting of:
9 = Operating instructions
NOTE: (Electronic engine power control adapter) For checking of electronic engine power control safety circuit with 20-pin engine connector
Storage Location
H 106
Adapter MP
NOTE: (Adapter kit) For measuring secondary voltage during static ignition distribution
Storage Location
K 104
SI number
02 06 92 (548)
Consisting of:
6 = Plate
NOTE: (Adapter plate) For engines with ignition coil block for measuring secondary voltage Deletion, only available via tool set
9 = Adapter
NOTE: (Single adapter (8 pieces)) Deletion, only available via tool set
9 = Cable
NOTE: (Cable) For BMW SERVICE TEST Deletion, only available via tool set
9 = Cable
NOTE: (Cable) Consisting of 7 individual cables Deletion, only available via tool set
9 = Clamp
NOTE: (Clamp) 8 pieces For ignition coils - engine: M43, M44 Deletion, only available via tool set
9 = Operating instructions
Adapter AM
NOTE: Adapter with multiple serrations (from 08/2009 as replacement for 12 7 121)
Storage Location
A49
Adapter Mechanical tool
NOTE: (Test adapter 35-pin) Universal wiring harness test adapter
Adapter MP
NOTE: For measuring primary voltage during static ignition distribution
Storage Location
H 103
SI number
02 01 90 (155)
Consisting of:
2 = Operating instructions
NOTE: (Adapter kit) For 134-pin module connector For diagnosis and troubleshooting in Digital Motor Electronics and transmission control unit - from model year 98
SI number
02 04 97 (248)
Consisting of:
4 = Cap
NOTE: (Zero-encoded protective cap for test box, 52-pin (12 1300/304)) New connector in E61/E61/E63 and E64 on SGM control unit protective cap 12 1 300/305 for diagnosis on wiring harness. From 08/2004 protective cap will be supplied with test box.
2 = Adapter cable
NOTE: (Adapter cable) 9-pin
2 = Measuring module
NOTE: (Measuring module) 24-pin
2 = Measuring module
NOTE: (Measuring module) 40-pin
2 = Measuring module
NOTE: (Measuring module) 52-pin Delivered from 08/2004 in combination with 12 1 305 (zero-encoded protective cap for new SGM control unit in E6x).
Adapter Mechanical tool
NOTE: (Test adapter, 56-pin) For checking the engine wiring harness on compressed natural gas vehicles
Storage Location
W 2..
SI number
01 14 95 (014)
NOTE: (plug adapter for CNG wiring harness) For reducing the gas pressure in the CNG system
Storage Location
W 2..
SI number
01 14 95 (014)
BMW X3 Service & Repair Manual > Heater with operation: Removing and installing/replacing servodrive for blending flap (right)
Necessary preliminary work:
Remove RIGHT GLOVE BOX WITH HOUSING
Release screws (1).
Detach actuator drive for air mix flap (2).
Unlock associated plug connection and disconnect.
Servomotors must be readdressed in the event of replacement!
Addressing can only be carried out with the ...