BMW X3 Service & Repair Manual: Removing and installing/replacing servodrive for blending flap (left)

BMW X3 Service & Repair Manual / HVAC / Heater with operation / Removing and installing/replacing servodrive for blending flap (left)

Necessary preliminary work:

  • Remove SUPPORT FOR DASHBOARD

Release screws (1).

Remove actuator drive (2).

Unlock plug connection (3) and disconnect.

HVAC

IMPORTANT: Servomotors must be readdressed in the event of replacement! Addressing can only be carried out with the BMW diagnosis system.

Service functions:

  • Body
  • Heating and air conditioning function
  • Flap motors
  • Readdress flap motors
    Removing and installing/replacing sensor for automatic recirculated air control (auc)
    Necessary preliminary work: REMOVING and installing/replacing right microfilter housing cover Remove filter cover (1) in direction of arrow. ...

    Removing and installing/replacing servodrive for blending flap (right)
    Necessary preliminary work: Remove RIGHT GLOVE BOX WITH HOUSING Release screws (1). Detach actuator drive for air mix flap (2). Unlock as ...

    Other materials:

    BMW X3 Service & Repair Manual > Luggage compartment floor: Replace luggage compartment floor and both side members (tail panel trim removed)
    Read contents of BODY, GENERAL. STRIP DOWN VEHICLE Place vehicle on straightening bench. Observe procedure of REPAIR STAGE 3. Following new body parts are required (refer to OVERVIEW OF CONSUMABLES): (1) Wheel arch extension, rear left and right (2) Luggage compartment floor, left an ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0616