Special tools required:
NOTE: When replacing the rubber mount in the wishbone, a wheel alignment .
Necessary preliminary work:
Press rubber mount out with special tools 31 1 051 , 31 1 054 and 33 3 054 .
Installation note:
Keep rubber mount and bore in control arm clean and free from grease.
Press rubber mount in and out at chamfered side of wishbone bore hole.
Installation note: Protrusion (A) = 5.74 Â+- 0.3 mm.
After installation: Carry out wheel alignment procedure .
BMW X3 Service & Repair Manual > Tire pressure monitor system reminder: Tpms reminder reset - procedure 1
1. Set the tire pressure on all wheels to specification.
2. Turn ignition switch to ON position, with engine off.
3. Press reset button (for no longer than 10 seconds) until tire pressure warning light illuminates Yellow for
a few seconds.
NOTE: On some X5 models, the reset button is marked ...