REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT COIL SPRING
Installation note:
1. All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
2. Retaining elements on chassis and suspension and steering parts must be replaced.
IMPORTANT:
- Both coil springs on the relevant axle must be replaced in the event of corrosion breakage.
- The spring pads at the top and bottom must also be renewed when replacing the coil springs.
NOTE: The process is described in THE REAR LEFT OR RIGHT SPRING STRUT.
After installation:
BMW X3 Service & Repair Manual > Brakes: Holding sleeve
Holding sleeve Mechanical tool
NOTE:
(Assembly sleeve) with a diameter of 22 mm to insert piston and sleeve into the
tandem brake master cylinder
NOTE:
(Assembly sleeve) For inserting the piston with sleeve into the tandem brake
master cylinder, dual-circuit brake system
...