Observe the following trolley-jack-related instructions:
1. Only trolley jacks sold or approved by BMW, with a rubber plate on their mounting, may be used! 2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used! 3. Check the rubber plate on the trolley jack prior to each use, replacing if necessary.
IMPORTANT: All-wheel drive vehicles may only be raised with the stiffening plate fitted on the front axle! Raising directly on the front axle support without stiffening plate is not permissible!
WARNING: The vehicle may be raised with a trolley jack only at the following mounting point!
NOTE: It is not permitted to raise the vehicle at the rear differential cover!
Risk of damage! Jacking point (1) must be present! Align the rubber plate on the trolley jack to the jacking point (1) in such a way that there is no contact to adjacent components and that they are therefore not damaged.
REAR AXLE LAYOUT
REAR AXLE: WHEEL ALIGNMENT CHECK MUST BE CARRIED OUT AFTER THE FOLLOWING WORK
A WHEEL ALIGNMENT CHECK must be carried out after the following work:
BMW X3 Service & Repair Manual > Transfer box special tools: Device
Device AM
NOTE:
For driving in the radial shaft seal in the transfer box on the output shaft at the
front
Consisting of:
1. Bush
NOTE: (Slip bush)
2. Mandrel
NOTE: (Drift)
Device AM
NOTE: For removing and installing the transfer box
SI number
01 08 93 (679)
Consisting of:
...