BMW X3 Service & Repair Manual: Removing and installing/replacing rear anti-roll bar

BMW X3 Service & Repair Manual / Suspension / Stabilizer bar / Removing and installing/replacing rear anti-roll bar

Necessary preliminary work:

  • Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR.
  • Lower REAR AXLE SUPPORT.

NOTE: To simplify the graphic, anti-roll bar removal is shown on the removed rear axle.

Release screws (1).

Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR.

Turn anti-roll bar (2) and remove from the side.

Suspension

Installation note:

Check both rubber mounts for damage and replace if necessary.

Keep retaining bracket, rubber mount and stabilizer clean and free from oil and grease.

REPLACING ANTI-ROLL BAR LINK FOR ANTI-ROLL BAR ON LEFT OR RIGHT

Release nuts (1); if necessary, grip at inner Torx socket.

Release screw (2).

Remove anti-roll bar link (3).

Installation note: Replace self-locking nut and screw.

Suspension

    Stabilizer bar
    ...

    Replacing both rubber mounts for anti-roll bar mounting
    Necessary preliminary work: Remove REAR WHEELS . Release screws (1). Pull off retaining bracket (2), open rubber mount (3) at slot and remov ...

    Other materials:

    BMW X3 Service & Repair Manual > Driveline+Axles: Specified grease
    GREASE FOR PROPELLER SHAFT (FLEXIBLE COUPLING (RUBBER DOUGHNUT) CENTER BEARING AND SPLINE END) Use one of the following greases for greasing the propeller shaft center bearing or locating pin of the transmission output flange and the splines of the propeller shaft spline end. GREASE FOR PROPELLE ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0088