Mandrel Mechanical tool
NOTE: (Drift) For driving in the retainer on the rear axle shaft
Storage Location
X8
Mandrel Mechanical tool
NOTE: (Guide mandrel) For fitting differential gear shaft into rear axle final drive
Storage Location
X4
Mandrel Mechanical tool
Replaced by: 83300492338
NOTE: (Drift) For radial seal on output flange - Replaced by 33 3 420. (0 492 338)
Mechanical Mandrel Minimum set: Mechanical tools 335080 tool
NOTE: For driving in shaft seal on drive shaft.
Storage Location
A16
SI number
01 21 06 (300)
Mandrel Mechanical tool
NOTE: (Drive-out mandrel) For the rear axle shaft/Replaced by 33 2 116. (0 492 175) and 33 4 200. (0 492 436)
Mandrel Mechanical tool
NOTE: (Drift) For driving in the retainer on the rear axle shaft (wheel bearing) and on the drive flange of the rear axle final drive (final drive types K and M)
Storage Location
A16
SI number
01 03 91 (333)
Mandrel Minimum set: Mechanical tools AM
NOTE: (Drift) For driving radial shaft seal of output shaft into rear axle final drive. Rear axle final drive: 215
Storage Location
B21
C21
SI number
01 01 07 (333)
Mandrel Mechanical tool
NOTE: (Drift) For driving in the radial seal rings in the rear axle final drive at the output flange with flange diameter 35 mm
Storage Location
X7
Mechanical Mandrel Minimum set: Mechanical tools 335130 tool
NOTE: For driving the radial shaft seal of the output shaft into the rear axle final drive.
Rear axle final drive: 188
Storage Location
C21
SI number
01 01 07 (333)
Mandrel Mechanical tool
Replaced by: 83300491891
NOTE: (Drift) Replaced by 31 2 040. (0 491 891)
Mandrel Minimum set: Mechanical tools Mechanical tool
NOTE: (Drift) For driving radial shaft seal onto drive flange. Replaced by 33 3 470/0 496 596
Storage Location
B26
SI number
01 09 09 (532)
Mandrel Mechanical tool
Replaced by: 83300492342
NOTE: (Drift) For driving the radial sealing ring into the output flange, flange diameter 43 mm - Replaced by 33 3 460. (0 492 342)
SI number
01 10 90 (288)
Mandrel Mechanical tool
Replaced by: 83300492338
NOTE: (Drift) For fitting the radial sealing ring, right-hand output end/Replaced by 33 3 420. (0 492 338)
Mandrel Mechanical tool
Replaced by: 83300492339
NOTE: (Drift) For driving the radial seal into the output flange with flange diameter 38 mm - Replaced by 33 3 430. (0 492 339)
Mandrel AM
NOTE: Discontinued, can only be ordered using complete tool
BMW X3 Service & Repair Manual > Rear brakes: Precision-turning both rear brake discs on both sides
IMPORTANT:
Always precision-turn both sides of both brake discs on one axle.
Maximum machining dimension per friction ring side is 0.8 mm!
Observe MINIMUM BRAKE DISC THICKNESS (MIN TH).
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may b ...