Shaped part AM
NOTE: (Shaped part)
Storage Location
Y8
SHAPED
Shaped part AM
NOTE: For removing the wheel bearing inner race from the drive flange hub in combination with special tool 33 4 400 and hydraulic tool 81 64 2 160 009.
Storage Location
C29
C30
SI number
01 15 11 (737)
SHAPED PART
Shaped part Minimum set: Mechanical tools AM
In conjunction with: 33 5 120 = 0495851
NOTE: For pressing output shaft out of rear axle final drive.
SI number
01 28 09 (600)
Shaped part Minimum set: Mechanical tools AM
NOTE: For driving output shaft into rear axle final drive.
SI number
01 28 09 (600)
Shaped part AM
NOTE: (Shaped part)
Shaped part Minimum set: Mechanical tools AM
NOTE: (Shaped part) 2 pieces Model series: E38, E39, E46 Deletion, only available via tool set
Storage Location
B8
Shaped part Minimum set: Mechanical tools AM
NOTE: (Shaped part)
Shaped part Minimum set: Mechanical tools AM
NOTE: (Shaped part) 2 pieces Model series: E39/2, E65, E67, RR1
BMW X3 Service & Repair Manual > Troubleshooting: Safety information for working on vehicles with automatic engine start-stop
function (msa)
WARNING:
If the engine hood/bonnet contact is pulled upwards (workshop mode), the
information "switch closed" is output. The automatic engine start-stop function
is active.
An automatic engine start is possible.
Observe safety precautions when working on MSA vehicles.
Before carrying out ...