BMW X3 Service & Repair Manual: Adjusting rear axle

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Renew nut (1) and eccentric bolt (2) and tighten to 5 Nm.

Turn eccentric bolt (2) to adjust camber to setpoint value.

Tighten nut (1).

Suspension

Adjusting toe:

Renew nut (2) and eccentric bolt (1) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust toe to setpoint value.

Tighten nut (2).

Suspension

    Additional work for camber correction
    IMPORTANT: Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment! NOTE: The swivel be ...

    Adjusting toe-in on front axle
    NOTE: Camber and toe-in influence each other. Adjust the toe-in first in order to simplify the adjustment procedure. Version with active steering: ...

    Other materials:

    BMW X3 Service & Repair Manual > Electronic damping force adjustment: Removing and installing/replacing control unit for vertical dynamic control
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary tasks: Remove ignition key. Disconnect BATTERY NEGATIVE CABLE . Remove FLAP IN LUGGAGE COMPARTMENT TRIM PANEL ON RIGHT . Undo screw (1), release expanding ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2022 Copyright www.bmwx3tech.com - 0.0755