Holder Mechanical tool
NOTE: (Counter support) For drift 32 1 140 when driving out the radial shaft seal together with bearing from the bearing bush
Storage Location
A13
SI number
01 05 95 (932)
HOLDING SLEEVE
Holding sleeve AM
Holding sleeve AM
NOTE: (assembly sleeves) For fitting the snap rings to the steering shaft
Storage Location
A8
Consisting of:
1. Pipe
NOTE: (Impact rod) discontinued, available as part of set of special tools only
2. Bush
NOTE: (slip bush) For fitting the snap ring when a flat nut is used for steering wheel mount - Model year: Up to 73, discontinued, available as part of set of special tools only
3. Bush
NOTE: (slip bush) For fitting the snap ring to the lower steering shaft bearing - Model: 2500... 3.0 CSi Deletion, only available via tool set
4. Bush
NOTE: (slip bush) For fitting the snap ring when a stop nut is used for steering wheel mount - Model year: From 74 discontinued, available as part of set of special tools only
BMW X3 Service & Repair Manual > Engine wiring loom: Replacing section of wiring harness for injectors (N47 D20 O1)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE
(ESD PROTECTION) .
Necessary preliminary work:
Read out the fault memory of the DDE control unit.
Switch off ignition.
Disconnect BATTERY EARTH LEAD .
Remove INTAKE FILTER HOUSING .
Remove rear aco ...