Holder Mechanical tool
NOTE: (Counter support) For releasing and tightening the gear selector cable/transmission with position switch
Storage Location
A4
SI number
01 06 92 (509)
Holder Minimum set: Mechanical tools AM
NOTE: For securing converter during removal and installation of transmission
Storage Location
C46
SI number
01 11 02 (908)
Consisting of:
3 = Shaped element
NOTE: For converter variant M57TU Deletion, only available via tool set
1 = Basic body
2 = Shaped element
NOTE: For converter version N73 discontinued, available as part of set of special tools only
4 = Shaped element
NOTE: For converter variant M54 Deletion, only available via tool set
5 = Shaped element
NOTE: Transmission: GA6 HP19 in E87, E90 Deletion, only available via tool set
6 = Shaped element
NOTE: Transmission: GA6L45R (GM6) in E83/N52K Deletion, only available via tool set
Holder AM
NOTE: (Dial gauge holder)
Holder Mechanical tool
NOTE: (Counter support) For slackening and tightening the gear selector cable
Storage Location
A4
SI number
01 04 91 (372)
Holder Mechanical tool
NOTE: (Counter support) For slackening and tightening the gear selector cable
Storage Location
A4
SI number
01 04 91 (372)
BMW X3 Service & Repair Manual > Heater with operation: Removing and installing/replacing ventilation temperature sensor
Necessary preliminary work:
Remove DECORATIVE STRIP ON DASHBOARD IN MIDDLE
Pull temperature sensor (1) out of retaining lug (2).
Installation note:
Make sure rubber ring is correctly seated.
Disconnect plug connection (1) and remove temperature sensor (2).
...