BMW X3 Service & Repair Manual: Removing and installing transfer box (atc 450)
Special tools required:
- 00 2 030
- 23 4 050
IMPORTANT: Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.
IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL and top up if necessary.
Failure to comply with this requirement will result in serious damage to the transfer box!
Necessary preliminary work:
- Disconnect BATTERY EARTH LEAD
- Remove PROPELLER SHAFT
- Remove FRONT PROPELLER SHAFT
NOTE: Support transmission with special tools 00 2 030 , 23 4 050 .
Release screws.
Remove transmission cross member.
Release screw (1), detach earth strap.
Unplug connector (1) from VTG control unit (linear force module) (3).
Release screw connection (1) of transfer box.
Take off transfer box (2).
Installation note:
Pay attention to dowel pin (1).
Grease dowel pin (1).
Apply a thin coat of grease to gearing.
Grease: WEICON ANTI-SEIZE.
Installing exchange transfer box (atc 45l)
IMPORTANT:
Before and after replacement, execute the "Repair" service function with the BMW diagnosis
system.
Recycling:
Catch and dispose ...
Removing and installing transfer box (atc 45l)
Special tools required:
00 2 030
23 4 050
IMPORTANT:
Before and after replacement, execute the "Repair" service function with the BMW di ...
Other materials:
BMW X3 Service & Repair Manual > Axle mounting: Replacing left or right rear axle support compression strut
IMPORTANT:
Observe safety information for raising the vehicle
Driving without compression struts is not permitted!
Risk of damage!
The rear axle support must be supported at the front if both compression struts need to be
replaced.
Release screws (1).
Release screw (2).
Install ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
