BMW X3 Service & Repair Manual: Bearing in housing, sealing ring

BMW X3 Service & Repair Manual / Transmission / Bearing in housing, sealing ring

Replacing radial shaft seal for output flange (gs6x45bz) - all- wheel drive vehicles

Special tools required:

  • 23 0 490
  • 24 0 110
  • 11 8 180
  • 2 286 572
  • 23 3 211
  • 23 3 210
  • 23 3 230

IMPORTANT: After completion of work, check transmission oil level.

Use only approved TRANSMISSION OIL .

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

  • Remove transfer box .
  • Engage gear.

Removal:

Block crankshaft with special tool 11 8 180 .

Transmission

Loosen and screw out screw (1) from the adapter shaft of the transmission (2).

Transmission

Mount special tool 2 286 572 C and 2 286 572 D on the adapter shaft.

Transmission

Screw in special tool 2 286 572 B in adapter shaft (1).

Pull out adapter shaft (1) using a two or three-claw extractor tool (2).

Transmission

Mount screw 2 286 572 A on special tool 23 3 211.

NOTE:

  • Special tool 23 3 211 is an element of special tool 23 3 210 .

Unscrew screw 2 286 572 A as far as possible out of special tool 23 3 211.

Screw special tool 23 3 211 tightly into radial shaft seal.

Transmission

Screw in screw 2 286 572 A into special tool 23 3 211 again until the radial shaft seal is drawn out of the transmission housing.

  • If necessary, repeat procedure.

Installation:

Coat sealing lips of new radial shaft seal with transmission oil.

Drive in radial shaft seal with special tool 23 3 230 until flush.

Transmission

Heat up adapter shaft (1) using a hot air blower (2).

NOTE: Maximum temperature of the adapter shaft: 120ºC.

Transmission

IMPORTANT: Risk of burning! Wear protective gloves.

Insert the heated adapter shaft (2) on the output.

  • If necessary, carefully hammer in the adapter shaft using a plastic hammer.

Part: Replace screw (1).

Tighten screw (1).

Transmission

Remove special tool 11 8 180 .

Transmission

Required follow-up work:

  • Install transfer box .
  • Check transmission oil level.

    Universal transmission retaining bridge
    Special tools required: 00 1 450 24 0 200 NOTE: The transmission retaining bridge 24 0 200 is suitable for automatic transmissions ...

    Other materials:

    BMW X3 Service & Repair Manual > Front axle: Spindle
    Spindle Minimum set: Mechanical tools AM Spindle AM NOTE: Spindle F3 (M24/270mm) in connection with adapter kit 1 (BMW), (81 64 2 155 745) and MINI adapter kit (81 64 2 294 517) for removal and installation of wheel bearings, propeller shafts and drive flanges. SI number 08 06 09 (544) ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0796