BMW X3 Service & Repair Manual: Renewing radial shaft seal for drive flange (atc 45l)

BMW X3 Service & Repair Manual / Transmission / Transmission shafts / Renewing radial shaft seal for drive flange (atc 45l)

Special tools required:

  • 23 0 490
  • 27 1 430

IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL and top up if necessary.

For this transfer box, use approved TRANSMISSION OIL only.

Necessary preliminary tasks:

  • Remove TRANSFER BOX.

Drive a hole into radial shaft seal (1) using a center punch (2).

IMPORTANT: Do not use a drill as swarf may result in transmission failure.

Transmission

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 23 0 490 into radial shaft seal.

Drive out radial shaft seal (1) with impact weight (2).

Transmission

Installation note:

Coat sealing lips of new radial shaft seal with clean transmission oil.

Drive in radial shaft seal with special tool 27 1 430 .

Transmission

Reassemble the vehicle.

Check oil level.

Check transmission for leaks.

    Transmission shafts
    ...

    Replacing output flange on rear transfer box (atc 45l)
    IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary. Use only the approved TRANSMISSION OIL . NOTE: ...

    Other materials:

    BMW X3 Owners Manual > High-beam Assistant: The concept
    When the low beams are activated, this system automatically switches the high beams on and off or suppresses the light in the areas that blind oncoming traffic. The procedure is controlled by a camera on the front of the interior rearview mirror. The assistant ensures that the high beams are a ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0791