BMW X3 Service & Repair Manual: Replacing radial shaft seal for output to the front axle (atc 45l)

BMW X3 Service & Repair Manual / Transmission / Transmission shafts / Replacing radial shaft seal for output to the front axle (atc 45l)

Special tools required:

  • 23 0 490
  • 27 1 470
  • 2 318 114

IMPORTANT: After completion of the repair work, CHECK GEARBOX OIL LEVEL.

For these transfer boxes, use approved TRANSMISSION OIL only.

Necessary preliminary tasks:

  • Remove front PROPELLER SHAFT .

Remove protective cap (1) with a screwdriver.

Transmission

Drive a hole into radial shaft seal (1) using a center punch (2).

IMPORTANT: Do not use a drill as drillings may result in transmission malfunction.

Transmission

Screw in special tool 23 0 490 .

Drive out radial shaft seal (1) with impact weight (2).

Transmission

Drive in radial shaft seal with special tool 2 318 114 .

Transmission

Reassemble the vehicle.

Check oil level.

Check transmission for leaks.

    Replacing radial shaft seal for output to the front axle (atc 450)
    Special tools required: 23 0 490 27 1 470 83 30 2 318 114 IMPORTANT: After completion of the repair work, check gearbox oil level. ...

    Transfer box special tools
    ...

    Other materials:

    BMW X3 Service & Repair Manual > Steering arms, tie rods, steer. damper: Instructions for removing and installing ear clips
    Special tools required: 32 1 260 NOTE: The work steps are show on assorted components. Ear clip must always be replaced. To remove an ear clip, place special tool 32 1 260 at right angles to ear and cut ear open. The ear clip can be fitted not only axially but also radially after the ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0775