BMW X3 Owners Manual: Display

BMW X3 Owners Manual / Controls / Displays / Head-up Display / Display

Overview

Speed.
Navigation system.
Check Control messages.
Selection list from the instrument cluster.
Driver assistance systems.
Some of this information is only displayed briefly as needed.

Selecting displays in the Head-up Display

On the Control Display:

1. "Settings"

2. "Head-Up Display"

3. "Displayed information"

4. Select the desired displays in the Head-up Display.

Settings are stored for the profile currently in use.

Setting the brightness The brightness is automatically adjusted to the ambient brightness.

The basic setting can be adjusted manually.

On the Control Display:

1. "Settings"

2. "Head-Up Display"

3. "Brightness"

4. Turn the controller.

When the low beams are activated, the brightness of the Head-up Display can be additionally influenced using the instrument lighting.

Settings are stored for the profile currently in use.

Adjusting the height

On the Control Display:

1. "Settings"

2. "Head-Up Display"

3. "Height"

4. Turn the controller.

Settings are stored for the profile currently in use.

Setting the rotation

On the Control Display:

1. "Settings"

2. "Head-Up Display"

3. "Rotation"

4. Turn the controller.

Settings are stored for the profile currently in use.

Special windshield

The windshield is part of the system.

The shape of the windshield makes it possible to display a precise image.

A film in the windshield prevents double images from being displayed.

Therefore, have the special windshield replaced by a service center only.

The concept

This system projects important information into the driver's field of vision, e.g., the speed. The driver can get information without averting ...

Lights

Vehicle features and options This chapter describes all standard, country-specific and optional features offered with the series. It also describes ...

Other materials:

BMW X3 Service & Repair Manual > Electronic switching or control units: Removing/replacing knock sensor (3rd and 4th cylinder) (N20, N26)
Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Remove STARTER MOTOR. Unlock connector (1) and remove. Release bolt (2) on knock sensor. Remove knock sensor for 3rd and 4th cylinders. Installation note: Clean contact surface of ...