Display If a collision with a recognized vehicle is imminent a warning symbol appears in the instrument cluster and in the Head-Up Display.
The vehicle lights up red:
prewarning.
Brake and increase distance.
The vehicle flashes red and an
acoustic signal sounds: acute warning.
You are requested to intervene by braking or make an evasive maneuver.
Prewarning This warning is issued, e.g., when there is the impending danger of a collision or the distance to the vehicle ahead is too small.
The driver must intervene actively when there is a prewarning.
Acute warning with braking function Warning of the imminent danger of a collision when the vehicle approaches another object at a relatively high differential speed.
The driver must intervene actively when there is an acute warning. If necessary, the driver is assisted by an automatic braking intervention in a possible risk of collision.
Acute warnings can also be triggered without previous prewarning.
Braking intervention The warning prompts the driver himself/herself to react. During a warning, the maximum braking force is used. Premise for the brake booster is sufficiently quick and hard stepping on the brake pedal. The system can assist with automatic braking intervention if there is risk of a collision. The intervention can bring the vehicle to a complete stop.
The braking intervention is executed only if DSC Dynamic Stability Control is switched on and Dynamic Traction Control DTC is activated.
Above approx. 130 mph/210 km/h the braking intervention occurs as a brief braking pressure.
No automatic delay occurs.
The braking intervention can be interrupted by stepping on the accelerator pedal or by actively moving the steering wheel.
Object detection can be restricted. Limitations of the detection range and functional restrictions are to be considered.
BMW X3 Service & Repair Manual > Rear axle repair instructions: Replacing shaft seal(s) for output shaft(s) in rear axle final drive
Special tools required:
00 5 010
32 1 060
33 1 308
33 5 130
33 5 140
Necessary preliminary work:
Remove REAR AXLE FINAL DRIVE.
Use special tools 00 5 010 and 32 1 060 /33 1 308 to remove radial shaft seal
Installing new shaft seal:
NOTE:
The installation protective ri ...