BMW X3 Owners Manual: Switching on/off

BMW X3 Owners Manual / Controls / Safety / Active Blind Spot Detection / Switching on/off

Switching on automatically The Active Blind Spot Detection is automatically activated after departure, if the function was switched on the last time the engine was stopped.

Switching on/off manually

Press button briefly:

The menu for the intelligent safety system is displayed. The systems are individually switched off according to their respective settings.
LED lights up orange or goes out respective to their individual settings.

Adjust as needed. Individual settings are stored for the profile currently in use.

Press button again:

All Intelligent Safety systems are activated.
The LED lights up green.

Hold down button:

All Intelligent Safety systems are turned off.
The LED goes out.

At a glance

Button in the vehicle Intelligent Safety button Radar sensors The radar sensors are located under the rear bumper. ...

Display

Lamp in the exterior mirror housing Information stage The dimmed lamp in the exterior mirror housing indicates when there are vehicles in the ...

Other materials:

BMW X3 Service & Repair Manual > Transmission fluid change intervals (if applicable): Condition based service (applies to certain vehicles only) - service bulletin si b 00 07 02 (2/2009)
NOTE: This Service Information bulletin supersedes SI B00 07 02 dated November 2007. SUBJECT Condition Based Service MODEL All models with Condition Based Service SITUATION This information is intended to provide a general system overview of Condition Based Service (CBS), which is an advan ...