BMW X3 Service & Repair Manual: Replacing engine support/front left side frame connection (front left wheel arch removed)

BMW X3 Service & Repair Manual / Body and Frame / Wheel wells / Replacing engine support/front left side frame connection (front left wheel arch removed)

Observe procedure for REPAIR STAGE 3.

Read contents of BODY, GENERAL.

Following new body parts are required:

  • (1) Engine support, rear

Body+and+Frame

Removing the engine support side frame connection: Open welded connections in areas (1).

Body+and+Frame

Open welded connections in areas (1).

Remove engine support/side frame (2).

Body+and+Frame

Open welded connections in areas (1).

Remove reinforcement (2).

Body+and+Frame

New part preparation

Open welded connections in areas (1).

Remove engine support (2).

Body+and+Frame

Installing the engine support side frame connection

Install and weld new parts.

NOTE: First, the reinforcement of the engine support side frame connection must be installed and welded for reasons of accessibility as a separate component.

NOTE: The bulkhead cross member (1) is filled with low-flammable cavity foam.

In case of smoke formation, stop the welding procedure and cool the welded area with compressed air if applicable.

  • (2) Bulkhead
  • (3) Connection engine support side frame
  • (4) Engine support

Body+and+Frame

REPLACING ENGINE SUPPORT/FRONT RIGHT SIDE FRAME CONNECTION (FRONT RIGHT WHEEL ARCH REMOVED)

The work is identical to replacing the "ENGINE SUPPORT FRONT LEFT SIDE FRAME CONNECTION".

    Replace front right wheel arch
    Note the special vehicle identification number procedure when replacing the wheel arch (order the new body part with the vehicle identification num ...

    Replacing front left wheel arch
    Follow procedure for REPAIR STAGE 3. Read contents of BODY, GENERAL. STRIP DOWN vehicle. Use only approved SPOT-WELDING APPARATUS for repairs ...

    Other materials:

    BMW X3 Service & Repair Manual > Troubleshooting: Instructions for welding work (overload protection of control units)
    CAUTION: Follow instructions for body repairs. When performing welding work on installed control units, to avoid any defects in the electronic control units, observe the following steps: Observe instructions for disconnecting and connecting battery. Detach terminal of battery negative l ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0743