NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
- Disconnect negative battery cable
- Remove bumper trim
- Remove front underbody protection assembly
- Remove front panel
- Remove front right side wall
- Remove DSC hydraulic unit
- Remove front wheel arch cover (front section)
- Remove front wheel arch cover (rear section)
- Remove engine compartment lid
- Remove right engine compartment lid hinge
- Remove right partition wall for units compartment
- Remove trailing link on right spring strut dome
- Remove microfilter housing
- Release right wiring harness
- Remove trailing link
- Remove right wishbone
- Remove spring strut with swivel bearing
BMW X3 Service & Repair Manual > Electronic chassis alignment: Moving vehicle into design position
Necessary preliminary tasks:
Move VEHICLE INTO NORMAL POSITION.
F01/F02/F07/F11/F15/F16: Version with air suspension system:
Remove ignition key.
Pull fuse for air supply unit control unit.
Add/distribute weights in area of spring struts until the vehicle ride height is within ...