BMW X3 Service & Repair Manual: Removing and installing/replacing tandem brake master cylinder for dsc

BMW X3 Service & Repair Manual / Brakes / Master brake cylinder / Removing and installing/replacing tandem brake master cylinder for dsc

Necessary preliminary tasks:

  • Read and comply with GENERAL INFORMATION.
  • Remove EXPANSION TANK.
  • REMOVE left partition wall for units compartment.

After completing repair work, bleed BRAKE SYSTEM WITH DSC.

IMPORTANT: Before beginning repair work, fully press the brake pedal several times to reduce the vacuum pressure in the brake servo.

Undo pipes (1) and close off.

Undo nuts (2) and pull tandem brake master cylinder (3) out of the brake servo.

Installation note: Replace self-locking nuts.

Brakes

Installation note: Replace sealing ring (1).

When inserting the tandem brake master cylinder, the brake servo, make sure that the pushrod of the brake servo and the tandem brake master cylinder are exactly aligned with each other.

Brakes

    Removing and installing/replacing expansion tank for hydraulic brake control
    Necessary preliminary tasks: Read and comply with GENERAL INFORMATION. Remove COWL PANEL COVER /service opening on left. NOTE: Extract ...

    Brake lines
    OVERVIEW OF BRAKE LINES ...

    Other materials:

    BMW X3 Service & Repair Manual > Rear control and suspension elements: Replacing rear left or right spring strut shock absorber
    Special tools required: 31 3 340 31 3 341 31 3 353 33 0 040 WARNING: Completely read the respective operating instructions before using special tools 31 3 340 ! Strictly adhere to all safety information and instructions in the operating instructions! Failure to observe these safet ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.081