BMW X3 Service & Repair Manual: Removing and installing control unit for parking brake
BMW X3 Service & Repair Manual / Brakes / Parking brake / Removing and installing control unit for parking brake
IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).
Necessary preliminary work:
- Raise luggage compartment floor trim.
Disconnect plug connection (1) and remove control unit (2).
Replacement:
- Carry out programming/encoding of control units.
Electromechanical parking brake - emergency release
Necessary preliminary tasks:
Remove EMF ACTUATORS on left and right.
IMPORTANT: Secure vehicle against rolling, e.g. with chocks.
Using a ...
Removing and installing/replacing emf actuator
Necessary preliminary tasks:
Release parking brake.
Switch off ignition.
IMPORTANT:
Switch off ignition at least 30 s before disconnect ...
Other materials:
BMW X3 Service & Repair Manual > Starter lead: Replacing positive battery cable between starter motor, alternator and
positive battery connection point (N55)
Necessary preliminary work:
Read out the fault memory of the DME control unit.
Switch off ignition.
Disconnect BATTERY EARTH LEAD .
REMOVE intake plenum.
Fold back cover (1).
Release nut underneath. Remove positive battery cable from battery positive terminal.
Remove protective ca ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
© 2017-2024 Copyright www.bmwx3tech.com - 0.0308