Shaped part AM
NOTE: (Shaped parts)
SHELL
Shell Mechanical tool
NOTE: (bearing shells) 2 pieces For the pressure accumulator of the H31brake system
Storage Location
Y2
SI number
01 04 88 (906)
SOCKET
Socket Mechanical tool
NOTE: For installing the DSC 3 pressure sensor - from 9/98
Storage Location
A11
SI number
01 14 98 (343)
SOCKET WRENCH INSERT
Socket wrench insert Mechanical tool
NOTE: (Screwdriver insert) For front brake calipers - Deletion since June 85
NOTE: Hexagon socket WAF 7, connection 1/2" for replacing the brake pads
Storage Location
X3
NOTE: (Screwdriver insert) For releasing and tightening the spline socket screws on the fixed brake yoke at the front and rear
Storage Location
C7
BMW X3 Service & Repair Manual > Wheel wells: Replacing rear left outer wheel arch section with reinforcement (rear side
panel removed)
Follow procedure for REPAIR STAGE 3.
Read contents of BODY, GENERAL.
Spot-weld bonding is used on this vehicle. Observe specific procedure .
Use only approved SPOT-WELDING APPARATUS for repairs.
Following new body parts are required :
(1) Wheel arch, rear, outer half
(2) C-pillar ...