BMW X3 Service & Repair Manual: Gauge

Gauge Minimum set: Mechanical tools AM

Replaced by: 83300493311

NOTE: (Adjusting gauge) For adjusting the full load stop (kickdown switch) on the accelerator. Replaced by 35 0 012. (0 493 311)

Storage Location

C32

SI number

01 11 94 (858)

Consisting of:

4 = Gauge

NOTE: (Adjusting gauge) From model year 8/97 and retroactively

4 = Gauge

NOTE: (Adjusting gauge) Replaced by 35 0 012 (0 493 311)

Brakes

Gauge Mechanical tool

NOTE: (Adjusting gauge) For adjusting the full load stop on the accelerator

Storage Location

Y3

SI number

01 11 94 (858)

Brakes

Gauge Minimum set: Mechanical tools AM

NOTE: (Adjusting gauge) From model year 8/97 and retroactively

Storage Location

B4

C4

Brakes

Replaced by: 83300493311

NOTE: (Adjusting gauge) Replaced by 35 0 012 (0 493 311)

Brakes

    Device
    Device AM NOTE: (Drilling device) For brake pedal, additional locking pin. Consisting of: 1. Template NOTE: (Drilling template, left-hand ...

    Holding sleeve
    Holding sleeve AM NOTE: (Clamping sleeve Ø 3x30 1 set (10 units)) TEMPLATE Template AM NOTE: (Drilling template, right-hand drive vehic ...

    Other materials:

    BMW X3 Service & Repair Manual > Output shafts: Removing and installing/replacing both output shafts
    IMPORTANT: The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed. The circlip of the output shaft must be replaced after re-installation. NOTE: The procedure is described in PRESSING OUTPUT SHAFT OUT OF DRIVE FLANGE AN ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0512