Special tools required:
NOTE: If the wishbone is detached from the front axle support, it will be necessary to carry out the wheel alignment procedure .
Necessary preliminary work:
IMPORTANT: Do not release wishbone from swivel bearing with impact tool.
Check rubber boot and tension ring for damage! When reinstalling the wishbone, check the seal seat for the tension ring between wishbone and swivel bearing and replace wishbone, if applicable!
If necessary, remove link for ride-height sensor at wishbone on left.
Release nut (1) approx. 3-4 thread turns; if necessary, counter support at Torx socket.
If necessary, replace lower section 31 2 242 with lower section 31 2 246 Use special tool 31 2 240 to press wishbone from swivel bearing.
Unscrew nut (1) and remove control arm.
Installation note: Keep journal on ball head and bushing in swivel bearing clean and free from oil and grease.
Replace self-locking nut.
Slacken nut (1).
Remove bolt towards front, remove wishbone (2).
Installation note: Screw head must point in direction of travel.
Tighten down screw connection in NORMAL POSITION .
Replace screw and nut.
After installation:
REMOVING AND INSTALLING/REPLACING BOTH TRAILING LINKS
NOTE: The procedure is described in Removing and installing/replacing left or right trailing link.
BMW X3 Owners Manual > Front-end collision warning
with City Braking function: System limits
Detection range
The system's detection potential is limited.
Thus a warning might not be issued or be issued
late.
E. g. the following situations may not be detected:
Slow moving vehicles when you approach
them at high speed.
Vehicles that suddenly swerve in front of
you, or sharpl ...