Special tools required:
NOTE: When replacing the rubber mount in the wishbone, a wheel alignment .
Necessary preliminary work:
Press rubber mount out with special tools 31 1 051 , 31 1 054 and 33 3 054 .
Installation note: Keep rubber mount and bore in control arm clean and free from grease.
Press rubber mount in and out at chamfered side of wishbone bore hole.
Installation note: Protrusion (A) = 5.74 Â+- 0.3 mm.
After installation:
BMW X3 Service & Repair Manual > Electronic chassis alignment: Moving vehicle into design position
Necessary preliminary tasks:
Move VEHICLE INTO NORMAL POSITION.
F01/F02/F07/F11/F15/F16: Version with air suspension system:
Remove ignition key.
Pull fuse for air supply unit control unit.
Add/distribute weights in area of spring struts until the vehicle ride height is within ...