BMW X3 Service & Repair Manual: Replacing anti-roll bar link for anti-roll bar on left or right

BMW X3 Service & Repair Manual / Driveline+Axles / Stabilizer bar / Replacing anti-roll bar link for anti-roll bar on left or right

Release nuts (1); if necessary, grip at inner Torx socket.

Release screw (2).

Remove anti-roll bar link (3).

Installation note: Replace self-locking nut and screw.

Driveline+Axles

    Removing and installing/replacing rear anti-roll bar
    Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR. Lower REAR AXLE SUPPORT. NOTE: To simplify the graphic, anti-roll bar removal is shown on ...

    Replacing both rubber mounts for anti-roll bar mounting
    Necessary preliminary work: Remove REAR WHEELS . Release screws (1). Pull off retaining bracket (2), open rubber mount (3) at slot and remov ...

    Other materials:

    BMW X3 Service & Repair Manual > Electronic switching or control units: Replacing crankshaft pulse sensor (N55)
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Remove STARTER MOTOR. Unlock connector (1) and remove. Release screw (2) ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2022 Copyright www.bmwx3tech.com - 0.0837