Necessary preliminary work:
Release screws (1).
Pull off retaining bracket (2), open rubber mount (3) at slot and remove.
Installation note:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean rear anti-roll bar on both sides.
Position rubber mount on rear anti-roll bar.
Mount retaining bracket (2) on rubber mount (3).
BMW X3 Service & Repair Manual > Master brake cylinder: Removing and installing/replacing tandem brake master cylinder for dsc
Necessary preliminary tasks:
Read and comply with GENERAL INFORMATION.
Remove EXPANSION TANK.
REMOVE left partition wall for units compartment.
After completing repair work, bleed BRAKE SYSTEM WITH DSC.
IMPORTANT:
Before beginning repair work, fully press the brake pedal several tim ...