BMW X3 Service & Repair Manual: Coding control module (dme/dde)

Switch on ignition.

Connect MoDiC or DIS/GT1 Tester.

Select "Coding" program.

For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.

Carry out adjustment of following control units:

  • EWS (electronic immobilizer)
  • DME (Digital Motor Electronics) or
  • DDE (Digital Diesel Electronics)

Refer to "Diagnosis and Coding" service information bulletins on subject of coding.

PROGRAMMING CONTROL UNIT (DME/DDE)

Switch on ignition.

Connect MoDiC or DIS/GT1 Tester.

Select "Programming".

For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.

Carry out adjustment of following control units:

  • EWS (electronic immobilizer)
  • DME (Digital Motor Electronics) or
  • DDE (Digital Diesel Electronics)

Refer to "Diagnosis and Coding" service information bulletins on subject of programming.

    Electronic switching or control units
    ...

    Removing/replacing knock sensor (1st and 2nd cylinder) (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Remove THROTTLE VALVE ASSEMBLY . Unloc ...

    Other materials:

    BMW X3 Service & Repair Manual > Ac housing/evaporator, switching elements: Removing and installing/renewing evaporator
    Necessary preliminary work: Remove HEATER/AIR CONDITIONER Carefully pull rubber grommet (1) and foam seal (2) over pipes (3) and (4). NOTE: If necessary, replace rubber grommet (1) and/or foam seal (2). Release screws (5). Unfasten plug connection (1) and disconnect. Carefully remove ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0823