BMW X3 Service & Repair Manual: Replacing suction pressure sensor on intake plenum (N55)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing suction pressure sensor on intake plenum (N55)

Necessary preliminary work:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.
  • Remove INTAKE FILTER HOUSING .

Release connector (1) and remove.

Release screws and pull suction pressure sensor (2) out of intake plenum.

Electrical

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Electrical

NOTE: Reassemble the vehicle.

Check stored fault message.

Delete fault memory.

    Replacing suction pressure sensor on intake plenum (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Partially undo the acoustic cover. Unl ...

    Replacing suction pressure sensor on pressure pipe (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Unlock connector (1) and remove. Unfa ...

    Other materials:

    BMW X3 Service & Repair Manual > Front axle: Bolt
    Bolt AM Replaced by: 83300492053 NOTE: Replaced by 32 3 090. (0 492 053) Bolt Mechanical tool NOTE: (drive pin) For radial gears in the front axle differential for checking the coefficient of friction BRIDGE Bridge Minimum set: Mechanical tools AM NOTE: (Support bridge) All-wheel drive ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0723