BMW X3 Service & Repair Manual: Removing and installing alternator (N52T)

BMW X3 Service & Repair Manual / Electrical / Alternator with drive and mounting / Removing and installing alternator (N52T)

IMPORTANT: Aluminum-magnesium materials.

No steel screws/bolts may be used due to the threat of electrochemical corrosion.

A magnesium crankcase requires aluminum screws/bolts exclusively.

Aluminum screws/bolts must be replaced each time they are released .

Aluminum screws/bolts are permitted with and without color coding (blue).

For reliable identification: Aluminum screws/bolts are not magnetic .

Jointing torque and angle of rotation must be observed without fail (risk of damage) .

Necessary preliminary work:

  • Switch off ignition.
  • Disconnect BATTERY EARTH LEAD .
  • Remove INTAKE SILENCER HOUSING .
  • Remove ALTERNATOR DRIVE BELT .

Release connector (1) and remove.

Slacken nut (2).

Installation note:

Disconnect positive battery cable from alternator.

Release screws (3) and remove alternator.

Installation note:

Replace aluminum screws.

Electrical

Assemble engine.

    Alternator with drive and mounting
    ...

    Removing and installing or replacing alternator (N20, N26)
    Necessary preliminary tasks: Switch off ignition Disconnect BATTERY EARTH LEAD and cover. Remove INTAKE SILENCER HOUSING . Remove CLEAN AIR ...

    Other materials:

    BMW X3 Service & Repair Manual > Driveline+Axles: Output shaft
    NOTES ON REMOVING AND INSTALLING LOW PROFILE BAND CLAMPS Special tools required: 31 5 200 IMPORTANT: During removal Low Profile band clamp (dotted line) is overstretched and must not be reused! REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT OUTPUT SHAFT Special tools required: ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0326