Device Mechanical tool
NOTE: (Turning device) for ignition distributors - H. Korer
NOTE: (retainer) For holding the ignition distributor during removal of the cotter pin on the distributor pinion
DIE-PLATE
Die-plate AM
NOTE: (set of dies) Cable 4 mm2 /ignition lead
Storage Location
K 103
EPROM
EPROM AM
NOTE: (Eprom set)
Consisting of:
1. EPROM
NOTE: (Eprom 128 K-type)
2. EPROM
NOTE: (Eprom 256 K-type)
3. EPROM
4. EPROM
5. EPROM
6. EPROM
7. EPROM
8. EPROM
9. CaseNOTE: (Case)
EPROM AM
NOTE: (Eprom 256 K-type)
NOTE: (Eprom 128 K-type)
ELECTRONICS BOX
Electronics box Mechanical tool
NOTE: (Eprom deletion unit)
NOTE: (Eprom programming system)
FITTING AID
Fitting aid Mechanical tool
NOTE: Fitting aid for spark plug installation. Original BERU ZMH 001 rubber hose 0 890 00 001.
SI number
01 04 07 (352)
FORK
Fork Mechanical tool
NOTE: (Removal fork) For pressing vacuum hose off vacuum units of ignition distributors and carburetor
BMW X3 Service & Repair Manual > Final drive: Replacing shaft seal(s) for output shaft(s) in rear axle final drive
Special tools required:
00 5 010
32 1 060
33 1 308
33 5 130
33 5 140
Necessary preliminary work:
Remove REAR AXLE FINAL DRIVE.
Use special tools 00 5 010 and 32 1 060 /33 1 308 to remove radial shaft seal
Installing new shaft seal:
NOTE:
The installation protective ring ( ...