BMW X3 Service & Repair Manual: Replacing sealing cup for transmission housing (GA8HP45Z)
Special tools required:
- 24 2 390
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
IMPORTANT: After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove TRANSMISSION OIL SUMP.
- IF REQUIRED, REMOVE OIL ACCUMULATOR.
- Remove CROSS MEMBER .
IMPORTANT: Support transmission with workshop jack.
Unlock and disconnect connector (1) by turning.
Insert special tool 24 2 390 in sealing sleeve (1).
Release screw (1) and unlock sealing cup with slide (2).
NOTE: Make a note of installation position of sealing sleeve.
Pull out sealing cup (1).
Installation note:
Fit sealing sleeve in position (lug on inner surface). Turn until lug engages in groove of transmission. Slide in sealing cup.
Lug on sealing cup must not be damaged!
Replacing mechatronics (GA8HP45Z)
Special tools required:
24 1 430
24 2 390
IMPORTANT:
Do not let skin come in contact with transmission oil and do not inhale tra ...
Unlock transmission lock electronically
For various tasks, it is necessary to unlock and lock the parking lock.
Before releasing the parking lock, secure the vehicle against rolling away. ...
Other materials:
BMW X3 Service & Repair Manual > Rear axle: Ring
Ring AM
NOTE: (pipe) For extracting and press-fitting the rubber mount in the 13º trailing arm
Ring AM
NOTE:
(Clamping ring) Model series: F01, F02. Available only as complete special tool
set 33 4 400.
SI number
01 18 08 (482)
RING SPANNER
Ring spanner Minimum set: Mechanical tools M ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
