Follow procedure for REPAIR STAGE 3.
Read contents of BODY, GENERAL.
Use only APPROVED SPOT-WELDING APPARATUS for repairs.
Place vehicle on straightening bench.
Following new body parts are required (refer to OVERVIEW OF CONSUMABLES):
Removing the engine support
Open welded connections in area (1).
Mark severance cut in accordance with Dimension a and cut.
Dimension a=85 mm before wheel arch edge.
Remove section of engine support.
NOTE: Shown without carrier support for purposes of clarity.
Preparation of new part: Mark severance cut on new part in accordance with vehicle and cut.
Prepare REINFORCEMENT PLATE at severance cut.
Adjust new part to fit with alignment bracket or universal mount.
Installing engine support
Install new parts and reinforcement plates with alignment bracket or universal mount and weld.
MAG-weld new part in area (1).
Length of weld seam approx. 15 mm.
REPLACING ENGINE SUPPORT IN FRONT OF WHEEL ARCH, RIGHT
Operation is identical to REPLACING ENGINE SUPPORT IN FRONT OF WHEEL ARCH ON LEFT.
REPLACING ENGINE SUPPORT WITH FRONT RIGHT WHEEL ARCH IN FRONT OF BULKHEAD
Note the specific procedure with regard to the vehicle identification number (if necessary, order new body part with the vehicle identification number).
Operation is identical to REPLACING ENGINE SUPPORT IN FRONT OF BULKHEAD ON LEFT.
BMW X3 Owners Manual > Pedestrian warning with city
braking function: System limits
Detection range
The detection potential of the camera is limited.
Thus a warning might not be issued or be issued
late.
E. g. the following situations may not be detected:
Partially covered pedestrians.
Pedestrians that are not detected as such
because of the viewing angle or contour ...