BMW X3 (F25) Service & Repair Manual: Clutch pedal with linkage

BMW X3 (F25) Service & Repair Manual / Brakes / Clutch pedal with linkage

Removing and installing or replacing clutch pedal

IMPORTANT: After completion of work, perform a functional check.

Necessary preliminary work:

  • Remove left footwell trim .

Press plastic pin (1) together and press out.

Press out plastic pin (2).

If necessary, disconnect over-center helper spring.

Clutch hydraulic system remains connected! Remove clutch pedal.

Installation note: Replace plastic pins (1 and 2).

Brakes

Installation note: Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Brakes

Removing and installing/replacing over-center helper spring

Necessary preliminary work:

  • Remove pedal trim .

Press end of pin (1) together with offset pliers and press out pin.

Brakes

Push in pin (1) fully in direction of arrow.

Brakes

Detach retainers (1).

Installation note: Check retainers, replace if necessary.

Retainers must lie with both legs in the groove and snap audibly into place.

Slide out pin (2).

Installation note: Lightly grease pin.

Brakes

Remove over-centre helper spring (3).

There are two versions:

  1. Over-centre helper spring
  2. Reinforced over-centre helper spring

Assembly of over-centre helper spring:

  • Secure black holder (1) to clutch pedal
  • Smaller coil spacing of spring (2) points to black holder (1)
  • Secure grey holder (3) to bearing block

Brakes

Lightly grease holder and spring contact surfaces.

Installation note: Secure over-centre helper spring first with black holder to clutch pedal.

Gently press over-centre helper spring together and secure with grey holder to bearing block.

Connect clutch pedal to clutch master cylinder.

When replacing reinforced over-centre helper spring: Remove locking clamp (1).

Brakes

REPLACING BEARING BUSHES FOR CLUTCH PEDAL

Operation is described in: REMOVING AND INSTALLING CLUTCH PEDAL.

Brake pedal with linkage
REPLACING SPRING FOR BRAKE PEDAL Necessary preliminary work: Remove trim panel for pedal mechanism . Disconnect return spring (1). REPLAC ...

Accelerator pedal actuation
REMOVING AND INSTALLING OR REPLACING ACCELERATOR PEDAL MODULE Take off cap. Release screw. Pull accelerator pedal module upwards out of fixture ...

Other materials:

BMW X3 (F25) Service & Repair Manual > Transmission: Bearing in housing, sealing ring
Replacing radial shaft seal for output flange (gs6x45bz) - all- wheel drive vehicles Special tools required: 23 0 490 24 0 110 11 8 180 2 286 572 23 3 211 23 3 210 23 3 230 IMPORTANT: After completion of work, check transmission oil level. Use only approved TRANSMISSIO ...