IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Unlock connector (1) and remove.
Release screw (2).
Remove connector housing from crankcase.
Release screw (3).
Pull pulse sensor from crankcase and remove.
Installation note:
During installation of pulse sensor make sure that guide pin (1) of pulse sensor is inserted in guiding groove (2) of crankcase.
NOTE: Assemble engine.
Check stored fault message.
Delete fault memory.
BMW X3 Service & Repair Manual > Front sub-frame: Lowering/raising front axle support
Special tools required:
31 5 251
00 2 030
31 5 255
31 5 256
WARNING: Danger of injury!
Failure to comply with the following instructions may result in the vehicle
slipping off the lifting platform and critically injuring other persons.
When supporting components, make sure th ...