BMW X3 Service & Repair Manual: Replacing pulse sensor on exhaust camshaft (N20)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing pulse sensor on exhaust camshaft (N20)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.

Unlock connector (1) and remove.

Release screw (2).

Remove pulse sensor (2).

Check gasket, renew damaged gasket.

Electrical

NOTE: Check stored fault message.

Delete fault memory.

    Replacing crankshaft pulse sensor (N55)
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary tasks: Read ...

    Replacing pulse sensor on exhaust camshaft (N52T)
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary work: Read ...

    Other materials:

    BMW X3 Service & Repair Manual > Compressor: (removing and installing) Replacing a/c system compressor (N47N)
    Special tools required: 32 1 270 WARNING: Danger of injury! Refrigerant circuit is under high pressure! Observe the safety information for handling the R 134a refrigerant . Avoid contact with refrigerant and refrigerant fluid. FOLLOW SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT OIL ! ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0513