BMW X3 Service & Repair Manual: Replacing pulse sensor on exhaust camshaft (N52T)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing pulse sensor on exhaust camshaft (N52T)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.
  • Remove ACOUSTIC COVER

Release screw (1).

Release holder (2) from cylinder head.

Electrical

Release connector (1) and remove.

Release screw.

Installation note:

Replace screw.

Remove pulse sensor (2).

Installation note:

Replace gasket.

Electrical

NOTE: Check stored fault messages.

Delete fault memory.

    Replacing pulse sensor on exhaust camshaft (N20)
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary tasks: Read ...

    Replacing pulse sensor on exhaust camshaft (N55)
    IMPORTANT: Aluminum screws/bolts must be replaced each time they are released . Aluminum screws/bolts are permitted with and without color co ...

    Other materials:

    BMW X3 Service & Repair Manual > Compressor: Replacing a/c system compressor (N52)
    Special tools required: 00 9 030 32 1 270 WARNING: Danger of injury! Refrigerant circuit is under high pressure! Observe the safety information for handling the R 134a refrigerant . Avoid contact with refrigerant and refrigerant oil. FOLLOW SAFETY INSTRUCTIONS FOR HANDLING REFRIGERAN ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0774