BMW X3 Service & Repair Manual: Replacing suction pressure sensor on pressure pipe (N20, N26)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing suction pressure sensor on pressure pipe (N20, N26)

Necessary preliminary tasks:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.

Unlock connector (1) and remove.

Unfasten screws (2).

Pull suction pressure sensor (3) out of pressure pipe.

Electrical

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Electrical

NOTE: Reassemble the vehicle.

Check stored fault message.

Delete fault memory.

    Replacing suction pressure sensor on intake plenum (N55)
    Necessary preliminary work: Read out the fault memory of the DME control unit. Switch off ignition. Remove INTAKE FILTER HOUSING . Release ...

    Preheating relay
    REPLACING PREHEATING CONTROL UNIT (N47D20 O1) Necessary preliminary tasks: Switch off ignition. Remove INTAKE SILENCER HOUSING . Release pos ...

    Other materials:

    BMW X3 Owners Manual > Adjusting: Unlocking
    The settings are saved in the active profile. Doors 1. "Settings" 2. "Doors/key" 3. Select the symbol. 4. Select the desired function: "Driver's door only" Only the driver's door and the fuel filler flap are unlocked. Pressing again unlocks the entire ve ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0444