BMW X3 Service & Repair Manual: Removing and installing/renewing a brake anchor plate/brake guard plate at rear

BMW X3 Service & Repair Manual / Brakes / Rear brakes / Removing and installing/renewing a brake anchor plate/brake guard plate at rear

Necessary preliminary tasks:

  • Remove wheel bearing.

Unscrew bolts (1) and remove brake guard plate (2).

Installation note: Replace screws.

Remove retaining plate (2) in direction of arrow.

Feed out brake guard plate (3) over wheel hub.

Brakes

    Removing and installing or replacing rear left or right brake caliper (trw)
    Necessary preliminary tasks: Remove WHEEL . Read and comply with GENERAL INFORMATION. Switch off ignition. After completing repair work: BL ...

    Removing and installing/replacing vent valve for brake caliper
    Necessary preliminary work: Raise vehicle. Removal: Press brake pedal down to floor and secure with pedal support. NOTE: The pedal supp ...

    Other materials:

    BMW X3 Service & Repair Manual > Transmission in general: Risk of injury if oil comes into contact with eyes and skin
    Danger of injury! Contact with eyes or skin may result in injury! Possible symptoms are: Impaired sight Irritation of the eyes Reddening of the skin Rough and cracked skin Protective measures/rules of conduct: Wear safety goggles Wear oil-resistant protective gloves Observe co ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0787